Ipaddrshow - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

ipAddrShow

ipAddrShow
Displays IP address information for a switch or control processor (CP).
SYNOPSIS
ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot [-eth0 | -eth1 | -gate
DESCRIPTION
Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the command
without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on
a chassis.
On a standalone switch, the command displays the following information:
•
•
•
•
•
•
On modular platforms, the command displays the following information:
For the chassis:
•
•
For each CP:
•
•
•
•
If the IPFC network interface is configured for logical switches:
•
Local IPv6 addresses display the following identifiers:
•
•
444
Ethernet IP Address
Ethernet Subnet mask
The Gateway IP Address
Dynamic Host Control Protocol (DHCP): on or Off
Pv6 Autoconfiguration Enabled: Yes or No
Local IPv6 Addresses
Ethernet IP Address
Ethernet Subnet mask
Ethernet IP Address
Ethernet Subnet mask
Host Name
Gateway IP Address
IPFC address for Virtual Fabric ID
For each CP:
-
Backplane IP address
-
IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays:

All local IPv6 Addresses

Gateway IP addresses for both CPs
IP Address type:
-
static - A statically configured IPv6 address.
-
stateless - Acquired through stateless autoconfiguration.
IP Address state:
-
tentative
-
preferred
-
deprecated
Fabric OS Command Reference
53-1001764-01