Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 666

2
portCfg
To create a VLAN tag entry for a failover crossport interface with a VLAN ID of 200 and an L2 CoS value
of 1 and to display the configuration:
To delete a VLAN tag entry:
To delete a VLAN tag entry for a crossport:
FUNCTION
Configure tunnels, circuits, and management interfaces on the Brocade 7800/FX8-24
SYNOPSIS
portcfg action [slot/]ve_port options arguments
DESCRIPTION
Use this command to configure FCIP tunnels and FCIP circuits on the GbE/10GbE ports on the Brocade
7800 and FX8-24 platforms only and to configure the inband management on these platforms. The FCIP
tunnels on the local and remote GbE ports act as Virtual E_Ports (VE_Ports) connecting the local and
remote fabrics. The following operations can be performed with this command:
•
•
•
•
•
638
switch:admin> portcfg vlantag 8/xge0 add 192.168.11.20 200 1 -x
Operation Succeeded
switch:admin> portshow vlantag 8/xge0
Port: 8/xge0
Interface Address
Destination Address
----------------------------------------------------------
192.168.11.20
0.0.0.0
switch:admin> portcfg vlantag ge2 delete 192.168.2.10 200
Operation Succeeded
switch:admin> portcfg vlantag 8/xge0 delete 192.168.11.20 200 -x
Operation Succeeded
portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.
-
Configure a tunnel with the FCIP FastWrite feature.
-
Enable or disable Tape Pipelining.
-
Configure the compression options.
-
Configure an IPSec-enabled tunnel.
-
Configure VLAN tagging on the default FCIP circuit.
-
Configure Differentiated Services Code Point (DSCP) markings.
-
Set the committed rate or minimum and maximum rates for the default circuit.
-
Configure a tunnel for FICON emulation.
portcfg fcipcircuit - Create, modify, and delete additional FCIP circuits.
-
Set or modify the committed rate or minimum and maximum rates for the circuit.
-
Configure or change VLAN tagging on the default circuit.
-
Set or modify additional circuit parameters.
portcfg mgmtif - Configure the inband management interfaces.
portcfg mgmtroute - Configure the routes for the inband management interfaces.
portcfg autoneg - Enable or disable autonegotiation settings for 1GbE ports.
VlanId L2CoS Flags
200 1 Perm Net (crossport)
Fabric OS Command Reference
53-1002746-01