Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 121

-bpports itemlist
DIAGNOSTICS
When it detects failures, the test may report one or more of the following error messages. If errors
persist, contact Technical Support.
DATA
ERRSTAT
INIT
PORTDIED
STATS
TIMEOUT
XMIT
EXAMPLES
To run the test on blade ports 80-90 with one frame:
SEE ALSO
itemList,
Fabric OS Command Reference
53-1002746-01
8
Runs test at 8 Gbps (Default for Condor2).
16
Runs test at 16 Gbps (Condor3 only).
Specifies a list of blade ports to test. By default all valid blade ports in the specified
blade are tested. On the Brocade Encryption platforms, ports 80-103 are the only
valid ports, because these are the only blade ports with access to the Vader chip.
Refer to the itemList help page for further information on the itemlist parameter.
Data received does not match the data sent.
Errors were found in the ASIC statistics.
Port failed to initialize.
A previously initialized port went to an un-initialized state.
Errors were found in the ASIC statistics.
Did not receive a frame in the given timeout period.
Frame transmission failure.
switch:admin> bpportloopbacktest -bpports 80-90 -nframes 1
Running bpportloopbacktest ..............
Ram Init
Ob1 portloopbacktest on ports 80-90 lbMode 7 speed 4
Info: Vader port 0 recovering Rx Fifo
Info: Vader port 1 recovering Rx Fifo
Info: Vader port 2 recovering Rx Fifo
Info: Vader port 3 recovering Rx Fifo
Info: Vader port 4 recovering Rx Fifo
Info: Vader port 5 recovering Rx Fifo
Ob1 portloopbacktest on ports 80-90 PASSED
Test Complete: bpportloopbacktest Pass 1 of 1
Duration 0 hr, 0 min & 24 sec (0:0:24:599).
Cleaning up after test.......
passed.
portLoopbackTest
bpPortLoopbackTest
2
93