Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 983

Brocade fabric os command reference v7.1.0 (53-1002746-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
In a DCX-4S, slot 5 is occupied by a control processor blade (Blade ID 50). On a DCX, slot 5 is occupied
by the core blade (Blade ID 52).
OPERANDS
This command supports the following operands:
-p
-m
EXAMPLES
To display the status of all slots on a DCX 8510-8:
Fabric OS Command Reference
53-1002746-01
DISABLED
The blade is powered on but disabled.
FAULTY
The blade is faulty because an error was detected. A fault code of 53 may also
indicate the possibility of a rolling reboot detection (RRD) on the specified blade.
In the case of an RRD, investigate and correct the cause, then reboot the control
processor (CP) to recover the blade.
UNKNOWN
The blade is inserted but its state cannot be determined.
In addition to the basic slot status view, displays the following information about
power consumption:
Total direct current (DC) power consumption for the chassis and individual
values for each blade (in Watts). Usage for other components such the WWN
card or fans is included in the calculation but not listed per component. Note
that the data displayed in the "DC Power Consumption" column and in the
summary field "Total DC Power consumption" indicate the maximum allowed
power consumption, not a real-time value. Real-time power consumption data
is displayed for 16G platforms only with the chassisShow command.
Total alternating current (AC) power consumption in Watts. This value
indicates the maximum allowed AC power consumption; it is not a real-time
value.
AC efficiency, as a percentage of total and BTU.
Power efficiency in Watts/port and Watts/Gb.
In addition to the basic slot status view, displays the Brocade model name for
each blade.
switch:user> slotshow
Slot
Blade Type
ID
---------------------------------
1
SW BLADE
97
2
SW BLADE
96
3
SW BLADE
97
4
SW BLADE
96
5
CORE BLADE
98
6
CP BLADE
50
7
CP BLADE
50
8
CORE BLADE
98
9
SW BLADE
125
10
SW BLADE
126
11
SW BLADE
37
12
SW BLADE
55
Status
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
2
slotShow
955

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the StoreFabric SN6500B and is the answer not in the manual?

This manual is also suitable for:

Fabric os v7.1.0

Table of Contents