ipAddrShow
Displays IP address information for a switch or control processor (CP).
Synopsis
ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot_numb [-eth0 | -eth1 | -gate]
Description
Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the
command without arguments to display the IP address on a standalone switch, or the IP addresses
for both CPs on a chassis.
On a standalone switch, the command displays the following information:
On modular platforms, the command displays the following information:
For the chassis:
For each CP:
If the IPFC network interface is configured for logical switches:
For each CP:
Local IPv6 addresses display the following identifiers:
IP Address type:
Fabric OS Command Reference
53-1001764-02
•
Ethernet IP Address
•
Ethernet Subnet mask
•
The Gateway IP Address
•
Dynamic Host Control Protocol (DHCP): on or Off
•
Pv6 Autoconfiguration Enabled: Yes or No
•
Local IPv6 Addresses
•
Ethernet IP Address
•
Ethernet Subnet mask
•
Ethernet IP Address
•
Ethernet Subnet mask
•
Host Name
•
Gateway IP Address
•
IPFC address for Virtual Fabric ID
-
Backplane IP address
-
IPv6 Autoconfiguration Enabled: Yes or No
If enabled, the command displays:
•
All local IPv6 Addresses
•
Gateway IP addresses for both CPs
•
static - A statically configured IPv6 address.
2
ipAddrShow
425