Porttestshow - Brocade Communications Systems StoreFabric SN6500B Command Reference Manual

2

portTestShow

portTestShow
Displays information from portTest.
SYNOPSIS
porttestshow [-ports itemlist]
DESCRIPTION
Use this command to display a snapshot of information from portTest. The command output displays
statistical data about past test runs and values for parameters that were set when the test was run. Refer
to the portTest help page for more information on the displayed parameters. The output includes the
following information:
Port number
PortType
PortState
PortTypeToTest
Pattern
Seed
UserDelay
TotalIteration
CurrentIteration
TotalFail
ConsecutiveFail
StartTime
StopTime
Timeout
ErrorCode
860
Displays test status for the port. Values are PASS or FAIL.
Type of port tested.
Current State of portTest. Values are NO TEST, TESTING, or TEST DONE.
Groups of ports tested. Values are ALL_PORTS, ALL_E_PORTS,
ALL_L_PORTS, ALL_F_PORTS, ALL_LB_PORTS, or SINGLE_PORT.
The pattern of the test packets payload.
The seed value used with the selected pattern. The default seed value is 0xaa.
The delay between frames sent by portTest in milliseconds. The default value is
10 milliseconds (ms).
Total number of test iterations.
Current test iteration.
Total number of failed tests.
Number of consecutive failed tests.
portTest start time.
portTest end time.
Number of timed out tests.
Error code, if any.
Fabric OS Command Reference
53-1002746-01