Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 242

2
cryptoCfg
--resume_rekey
--discoverLUN
--show -container
--show -tapepool
214
-include_mirror
Initiates a manual rekey operation on all primary LUNs and mirror LUNs in
read-only state. In addition, this command also starts a manual rekey operation on
all primary and nonreplicated LUNs in read-write state.
Resumes a suspended rekey session for a specified disk LUN at the termination
point. A rekey session may terminate prematurely due to unrecoverable medium
or hardware errors. When a rekey session terminates prematurely, the system
logs CRITICAL RASlog and rekey operation failure status messages. You must
take corrective action to clear all error conditions that caused the rekey failure
before resuming a suspended rekey session. All DEK or HA cluster members
must be online and reachable for this operation to succeed.
crypto_target_container_name
Specifies the name of the CTC to which the LUN belongs.
LUN_Num
Specifies the number of the LUN to be rekeyed. Use the --show -container
command for a list of LUN numbers associated with the specified CTC.
initiator_PWWN
Specifies the initiator port WWN for the specified LUN.
Performs LUN discovery. This command discovers and displays all LUNs that are
discoverable by the initiators of a specified CTC. This command is valid only on
the node that hosts the CTC. The following operand is required:
crypto_target_container_name
Specifies the name of the CTC.
Displays all CTCs in the encryption group. This command is valid on all nodes.
The following operands are supported:
-all -cfg
Displays the configuration for all containers in the encryption group.
-all -stat
Displays the runtime status for all containers hosted on the local node only.
crypto_target_container_name
Displays information for the specified CryptoTarget container. If the -stat
parameter is specified with this operand, the CTC must be hosted on the local
node.
-cfg
Displays the configuration for the specified CTC.
-stat
Displays the runtime status for the specified CTC.
Displays configuration information for specified tape pools when used with the
-cfg option. Displays runtime status information for specified tape pools when
used with the -cfg option. This command is valid on all nodes. The following
operands are supported:
-all -cfg
Displays configuration information for all configured tape pools in the encryption
group.
Fabric OS Command Reference
53-1002746-01