Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 740

2
portCfgShow
vlantag
fciptunnel
mgmtif ge_port
mgmtroute ge_port
EXAMPLES
To display the port configuration settings for a single port on a Brocade DCX 8510-8:
712
Displays the VLAN tagging configuration. For each entry, the output displays the
IP interface address, the destination IP address, the VLAN ID, and the L2 CoS
priority. This display includes permanent entries only. Permanent entries are
configured at the IP interface level with the portCfg vlantag command. To view
VLAN tagged tunnels and circuits along with permanent entries, use the
portShow vlantag command.
Displays FCIP tunnels and related parameters. Valid arguments for fciptunnel
include the following:
all
Displays information for all FCIP tunnels.
ve_port
Displays information for the specified FCIP tunnel. To display the tunnel, specify
the VE_Port number associated with the tunnel configured on one of the GbE
ports. VE_Ports are numbered 16-23.
-ipsec
Displays whether IPSec is enabled or disabled. If enabled, the key is displayed. If
IPSec is enabled and configured in legacy mode, the mode is displayed as
"legacy". The mode information is displayed whether or not you issue the -ipsec
option. This operand is optional.
Displays the inband management interfaces configured for a specified GbE Port.
The display includes the interface status (enabled or disabled), the interface IPv4
Address, the netmask, effective MTU, and annotated port flags.
Displays the management routes configured for a specified GbE Port. The display
includes the destination IPv4 Address, the netmask, the gateway address, and
annotated port flags. The metric field is not valid for the Brocade 7800.
switch:admin> portcfgshow 10/38
Area Number:
Octet Speed Combo:
Speed Level:
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Desired Distance
Reserved Buffers
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
NPIV capability
QOS E_Port
Port Auto Disable:
Rate Limit
EX Port
Mirror Port
222
1(16G|8G|4G|2G)
AUTO(HW)
OFF
ON
LS
OFF
10 Km
86
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
AE
ON LOSG OLS NOS
OFF
OFF
OFF
LIP
Fabric OS Command Reference
53-1002746-01