Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 479

--help
EXAMPLES
To advertise all modes of operation, when not entering this command through the serial console port,
follow this scenario for the ifModeSet command:
To force the link for the eth0 interface from autonegotiation to 10 Mbps half-duplex operation, when
entering this command through the serial console port:
SEE ALSO
ifModeShow
Fabric OS Command Reference
53-1002746-01
Displays the command usage.
switch:admin> ifmodeset eth0
Exercise care when using this command.
an operating mode not supported by the network equipment to
which it is attached may result in an inability to
communicate with the system through its ethernet interface.
It is recommended that you only use this command from the
serial console port.
Are you sure you really want to do this? (yes, y, no, n): [no] y
Proceed with caution.
Auto-negotiate (yes, y, no, n): [no] y
Advertise 100 Mbps / Full Duplex (yes, y, no, n): [yes] y
Advertise 100 Mbps / Half Duplex (yes, y, no, n): [yes] y
Advertise 10 Mbps / Full Duplex (yes, y, no, n): [yes] y
Advertise 10 Mbps / Half Duplex (yes, y, no, n): [yes] y
Committing configuration...done.
switch:admin> ifmodeset eth0
Auto-negotiate (yes, y, no, n): [yes] n
Force 100 Mbps / Full Duplex (yes, y, no, n): [no] n
Force 100 Mbps / Half Duplex (yes, y, no, n): [no] n
Force 10 Mbps / Full Duplex (yes, y, no, n): [no] n
Force 10 Mbps / Half Duplex (yes, y, no, n): [no] y
Committing configuration...done.
ifModeSet
Forcing the link to
2
451