Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 692

2
portCfgDPort
--enable
--disable
--help
EXAMPLES
To configure a single port as a D_Port:
To clear the D_Port configuration:
SEE ALSO
fabricLog, portCfg, portDPortTest, portShow,
664
•
A set of ports separated by commas, for example "3,5,7,8"or 5/3,5,7,8 on
bladed systems.
•
A wildcard '*' indicates all ports. The wild card should be enclosed in single
quotation marks.
Configures the specified ports as D_Ports.
-dwdm
Skips the optical loopback test when you run the D_Port diagnostics over a Dense
Wavelength Division Multiplexing (DWDM) link or any third party equipment that
connects two switches. This operand is optional.
Clears the D_Port configuration on the specified ports.
Displays the command usage.
switch:admin> portdisable 42
switch:admin> portcfgdport --enable 42
switch:admin> portenable 42
switch:admin> portdisable 42
switch:admin> portcfgdport --disable 42
switch:admin> portenable 42
switchShow
Fabric OS Command Reference
53-1002746-01