Table of Contents
Advertisement
Chapter 9
Troubleshooting the CTS 3010 and CTS 3210
Testing the CTS 3010 and CTS 3210 Cameras
The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera's focus.
The following sections describe how to set up the CTS 3010 and CTS 3210 cameras for testing:
•
•
•
•
Starting the Software Setup
To start the software setup, complete the following steps.
Step 1
Assemble the Large Camera Target.
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.
OL-13676-05
Starting the Software Setup, page 9-7
Adjusting the Zoom, page 9-9
Focusing the Camera, page 9-12
Attaching the Camera Hood Assembly, page 9-14
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
9-7
Advertisement
Table of Contents
Troubleshooting
