Replacing A Codec-Part Number Cts-5K-Encoder= Or Cts-5K-Hostcpu - Cisco TelePresence IX5000 Manual

Replacing a Codec—Part Number CTS-5K-ENCODER= or CTS-5K-HOSTCPU=
Step 14
Using two people, remove the display so that it lifts clear of the display shelf.
Step 15
Install the display and replace all other components in the reverse order that you removed them. Note
that this display goes on without the add-ons used for the left and right displays (spool and bracket).
Step 16
Be sure to power on the PDUs before you re-install the bottom fascia.
Replacing a Codec—Part Number CTS-5K-ENCODER= or
CTS-5K-HOSTCPU=
IMPORTANT NOTE
You must disconnect the power to the switch and the table, and disconnect the Touch 10 devices, after
you replace the codec. For more information, refer to the
section of the
Required Tools
•
•
IX5000 Field-Replaceable Units and Country- and Region-Specific Power Connectors
36
IX5000 and IX5200 First-Time Setup
#2 and #3 Phillips Driver
Wiring diagram
"Preventing Touch 10 Configuration Issues"
document.