Table of Contents
Advertisement
Managing Hardware Setup
Step 5
Adjust the camera mounting plate to center the red plus sign (+) on the display inside the black plus sign
(+) on the target.
Figure 7-22
Use the top two screws for left and right adjustment.
•
•
The lower screw for up and down adjustment.
The screws in the middle for adjustments on the horizontal plane (rotational).
•
Figure 7-22
Side to side
adjust screw
Step 6
Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
b.
Adjust the camera zoom so that the black curved line on the left of the target touches the left edge
of the display screen, as shown in
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Cisco TelePresence System Release 1.6 Administration Guide
7-26
shows the screws that you use to adjust the camera. Use a 2.5 mm Allen wrench.
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T."
adjust
Up/down
adjust
screw
Figure
7-23.
Chapter 7
Troubleshooting the CTS 1300
Right
screw
Side to side
adjust screw
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
