Chapter 7
Troubleshooting the CTS 1300
Note
Figure 7-13
Zoom ring
Step 8
Adjust the camera mounting plate to center the red plus sign (+) on the display inside the black plus sign
(+) on the target.
Figure 7-14
Use the top two screws for left and right adjustment.
•
•
The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
OL-13676-04
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure
7-13. The focus ring is the one that is nearest to the wall.
Location of Focus and Zoom Ring
shows the screws that you use to adjust the camera. Use a 2.5 mm Allen wrench.
Focus ring
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
7-19