Table of Contents
Advertisement
System Status
Cisco Unified Communications Manager Status
The Cisco Unified Communications Manager can be in the following states:
•
•
In a Call Indicator
The Status box tracks when the meeting room is in a call and displays the security level of active calls.
When in a call, the security level is determined between the two endpoints. There are five possible levels
of levels of security.
•
•
•
•
•
Cisco TelePresence System Release 1.6 Administration Guide
1-4
Question Mark—Microphone is not expected or
•
microphone is not connected.
Red X with a broken pipe—Device in inaccessible. This
•
icon is seen if the primary codec cannot communicate with
a secondary codec.
Red X—Device is not connected or device is not
•
configured:
Cameras—When the video cable is not connected or is
–
loose, or when the Ethernet cable is not connected.
Displays—When the video cable is not connected or
–
the display does not have power.
Projectors—If the video cable is unplugged or the unit
–
does not have power.
–
Microphones—Offline.
If you have specified in Cisco Unified
–
Communications Manager (Cisco Unified CM) that a
projector/LCD
OK
Inaccessible
Yes/Encrypted—Active call with both the signaling and the media encrypted.
Yes/Authenticated—Active call with encryption on the call signaling only.
Yes/Non-Secure—Active call with no authentication or encryption.
Yes/Not Available—Active call but the security level of that call is unavailable.
No—Not actively in a call.
Chapter 1
Using the Cisco TelePresence System Administration Interface
is present and there is not one present.
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
