Table of Contents
Advertisement
Managing Hardware Setup
c.
For PLV-Z5 projectors, perform the following procedure:
•
a.
b.
c.
Set the display by completing the following steps:
Step 5
Press the Up Arrow and Down Arrow keys and select Display.
a.
b.
Press the Right Arrow key and select Off.
Step 6
Set the logo by completing the following steps:
a.
Press the Up Arrow and Down Arrow keys and select Logo.
b.
Press the Right Arrow key and select Off.
Step 7
Select the image mode by completing the following steps:
Press the Up Arrow and Down Arrow keys and highlight Image.
a.
b.
Press the Right Arrow key and select Image to enter the Image submenu.
Press the Up Arrow and Down Arrow keys and highlight Vivid.
c.
Press the Right Arrow key and select Vivid.
d.
Press the Left Arrow key to confirm your selection.
e.
Select the screen size by completing the following steps:
Step 8
Press the Up Arrow and Down Arrow keys and highlight Screen.
a.
Press the Right Arrow key and select Screen to enter the Screen submenu.
b.
c.
Press the Up Arrow and Down Arrow keys and highlight Normal.
d.
Press the Right Arrow key and select Normal.
e.
Press the Left Arrow key to confirm your selection.
Step 9
Eliminate overscan by completing the following steps:
a.
Press the Up Arrow and Down Arrow keys and highlight Picture adj.
b.
Press the Right Arrow key and select Picture adj. to enter the Picture Adjustment submenu.
c.
Press the Right Arrow key and select Overscan.
Press the Left Arrow key and reduce the Overscan value to zero.
d.
Press the OK key to complete the Overscan setting.
e.
Press the Left Arrow key to confirm your selection.
f.
Set the lamp iris by completing the following steps:
Step 10
Press the Up Arrow and Down Arrow keys and highlight Image adj.
a.
Press the Right Arrow key and select Image adj. to enter the Image Adjustment submenu.
b.
c.
Press the Up Arrow and Down Arrow keys and highlight Advanced menu.
Press the Right Arrow key and select Advanced menu.
d.
e.
Press the Up Arrow and Down Arrow keys and highlight Lamp iris.
f.
Press the Right Arrow key and select Lamp iris.
g.
Press the Right Arrow key and select Open.
Cisco TelePresence System Release 1.6 Administration Guide
8-30
Press the Right Arrow key and select Off.
Press the Up Arrow and Down Arrow keys and highlight Background.
Press the Right Arrow key and select Background to enter the Background submenu.
Press the Right Arrow key and select Black.
Chapter 8
Troubleshooting the CTS 3000 and CTS 3200
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
