Cisco CTS-3010 Administration Manual page 249

Chapter 7 Troubleshooting the CTS 1300
Figure 7-49 Table Configuration Menu
d.
e.
Navigate to Troubleshooting > Hardware Setup > Cameras.
Step 6
Note If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
could configure your system for the incorrect table type. To select the correct table type, complete
in the
Click Start to start the camera test.
Step 7
Click Show Camera Target.
Step 8
Automatically adjust the cameras by completing the following steps.
Step 9
a.
b.
OL-13676-04
Click Apply.
Click Stop to stop the test.
"Positioning the Table and Starting the Calibration Procedure" section on page
In the Auto Brightness field, perform one of the following actions:
• If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
•
In the Auto Color Balance field, perform one of the following actions:
• If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
•
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Step 5
7-51.
7-53