Cisco CTS-3010 Administration Manual page 377

Chapter 9 Troubleshooting the CTS 3010 and CTS 3210
Managing Hardware Setup
Caution Do not overtighten the screws, or use a power screwdriver to tighten the screws. The recommended
torque for the screws is 0.8N.m (7 inch-pounds).

In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or
using a screw that is too long, can cause the plastic hoods to break.
Figure 9-10 Attaching the Camera Hood Assembly
7
2
1
3
7
Cisco TelePresence System Release 1.6 Administration Guide
9-15
OL-13676-05