Table of Contents
Advertisement
Chapter 4
Troubleshooting the CTS 500
Step 4
Click Start in the Testing box. The Auxiliary Control Unit (Current Status) is displayed. Individual light
units correspond to the five port numbers of the Auxiliary Control Unit, Ports 1 through 5.
a.
b.
c.
d.
e.
Click Stop to end the test.
Step 5
LEDs
Each CTS 500 has five LEDs located around the outside edges of the screen. If the user can see these
LEDs, the user is not sitting directly in front of the camera. This troubleshooting feature lets you view
and change the current state of the LEDs.
To test the LEDs, follow these steps:
Step 1
Log in to the Cisco TelePresence System Administration window.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Click the Other Devices radio button.
Step 4
Click the LEDs tab.
Step 5
Click Start in the Testing box.
•
•
Click the LED State On or Off button to change the current state of the LEDs.
Step 6
Click Stop to end the test.
Step 7
Shroud Light
Each CTS 500 has a separate shroud light. This troubleshooting feature lets you view or change the status
of the shroud light.
To test the shroud light, follow these steps:
Step 1
Log in to the Cisco TelePresence System Administration window.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Click the Other Devices radio button.
Step 4
Click the Light tab.
Step 5
Click Start in the Testing box.
OL-13676-05
Check a box to select a specific port number.
Or
Click Select All to select all ports (and all light units) or Select None.
Click the Refresh On/Off Status button to update the on/off status of each port.
Click the Turn Selected Lights On/Off to test the selected light unit(s).
Click the Reset Auxiliary Control Unit to power cycle the Auxiliary Control Unit.
If the LED feature is enabled, the LED State On button is highlighted.
If the LED feature is disabled, the LED State Off button is highlighted.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
4-29
Advertisement
Table of Contents
Troubleshooting
