Cisco CTS-3010 Administration Manual page 204

Managing Hardware Setup
•
•
•
•
•
•
•
•
•
•
Removing the Camera Cover and Leveling the Cameras
The camera cluster must be perfectly level for you to properly test the camera. To remove the camera
cover and level the camera, follow these steps:
Remove the camera cover by removing the four black plastic screws on the top and bottom of the camera
Step 1
assembly, as shown in
Cisco TelePresence System Release 1.6 Administration Guide
7-8
Removing the Camera Cover and Leveling the Cameras, page 7-8
Attaching the Large Camera Target to the Easel, page 7-11
Configuring the CTS 1300 for Use With a Conference Room Table, page 7-12
Configuring the CTS 1300 for Use With a Long Straight Table, Wide Rectangular Table, or Long
Racetrack table, page 7-13
Configuring the CTS 1300 for Use With a Short Racetrack Table, page 7-33
Configuring the CTS 1300 for Use With a Round Table, page 7-51
Configuring the CTS 1300 for Use With a Square Table, page 7-70
Saving Your Settings, page 7-49
Replacing the Camera Cover, page 7-50
Arranging the Seat Alignment Guides, page 7-88
Figure 7-3.
Chapter 7 Troubleshooting the CTS 1300
OL-13676-04