Cisco CTS-3010 Administration Manual page 225

Administration guide
Hide thumbs Also See for CTS-3010:
Table of Contents

Advertisement

Chapter 7
Troubleshooting the CTS 1300
Step 7
Click Done to complete the right camera focusing procedure.
Focusing the Right Camera
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
To focus the right camera, follow these steps:
Step 1
In the Cisco TelePresence Administration window, click the Right radio button.
Step 2
Click the Setup button that is located below the center screen icon.
Step 3
Click Show Focus Targets.
Step 4
Position the small camera target by completing the following steps:
a.
Place the target on the table one foot from the edge where the participants sit.
b.
Position the target so that the patterns on the target are enclosed in the green box.
Step 5
Position the large target by completing the following steps:
Remove the large focus target from the easel.
a.
Rotate the target 90 degrees.
b.
Have another person hold the target upright.
c.
Note
Place the top of the easel five feet behind the top of the small target.
d.
Position the target so that the topmost patterns are enclosed in the red box.
e.
Figure 7-25
OL-13676-04
"Positioning the Table and Starting the Calibration Procedure" section on page
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
shows the large and small target positions.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Step 5
7-51.
7-29

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Telepresence system

Table of Contents