Table of Contents
Advertisement
Managing Hardware Setup
Auto Adjusting the Camera
To tune the camera for brightness, color balance, and distance complete the steps in the following
sections:
•
•
•
Note
Fixed Artificial Lighting
If the room uses fixed artificial lighting, follow these steps:
Step 1
Click the Disable radio button for the Camera Auto Brightness and Camera Auto Color Balance choices.
Step 2
Click Setup, then click Auto Adjust to automatically adjust lighting and color balance.
Note
The camera calibrates and saves the settings. This process takes approximately 10 seconds.
Note
If you require further adjustments to the room brightness, click the Enable radio button for the Camera
Step 3
Auto Brightness and Camera Auto Color Balance choices, then select a choice from the Luminance
drop-down list until the brightness and contrast are at acceptable levels.
Outside Lighting
If the room uses outside lighting, or has any other conditions that could cause variable room lighting,
follow these steps:
Click the Enable radio button for the Camera Auto Brightness and Camera Auto Color Balance choices.
Step 1
Note
To make additional adjustments to the camera brightness and contrast levels, select a choice from the
Step 2
Luminance drop-down list.
In the 50 Hz Flicker Reduction field, click the Disable radio button.
Step 3
Cisco TelePresence System Release 1.6 Administration Guide
4-12
Fixed Artificial Lighting, page 4-12
Outside Lighting, page 4-12
Understanding Camera Setup Choices for Room Lighting, page 4-13
For more information about room lighting, see the
page
4-6.
Make sure that the large target is still in place and that nothing is between the large target and
the camera.
If the test fails, you may need to add more light to the room.
Auto Color Balance can produce undesirable results if the colors of the walls in your room are
not white or gray.
Chapter 4
Troubleshooting the CTS 500
"Testing the CTS 500 Camera" section on
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
