Snmp Settings - Cisco CTS-3010 Administration Manual

Chapter 3 Configuring the Cisco TelePresence System
Table 3-3
Field
Start Media Port
End Media Port
Use Cisco Unified CM to make changes to Telephony Settings. See the
Step 3
Manager Configuration Guide for the Cisco TelePresence

SNMP Settings

The Simple Network Management Protocol (SNMP) Settings window displays read-only information
about the SNMP settings for the Cisco TelePresence System that were set in the Cisco Unified CM
configuration.
To view SNMP settings, follow these steps:
Step 1 Choose Configuration > SNMP Settings.
Step 2 View the SNMP settings described in
Table 3-4
Field
Engine ID
OL-13676-05
Telephony Settings (continued)
Settings
Must be in the range from 16384 to 32766, and must be lower than
the End Media Port settings.
Must be in the range from 16384 to 32766, and must be higher than
the Start Media Port settings.
Table
SNMP Settings
Settings
Identifies the local or remote SNMP engine. The remote agent
SNMP engine ID and user password are used to compute
authentication and privacy digests.
Cisco TelePresence System Release 1.6 Administration Guide
System.
3-4:
SNMP Settings
Cisco Unified Communications
3-13