Testing Microphones On The Cts 1300; Related Information - Cisco CTS-3010 Administration Manual

Managing Hardware Setup

Related Information

For more information about setting up and testing speakers, see the
Assembly, Use & Care, and Field Replacement Unit
For more system troubleshooting information, see the
Guide
Testing Microphones
The microphones are set up successfully when each microphone registers sound. You must supply sound
at each microphone to complete this test.
The number of audio meters that are shown on the test screen is determined by the number of
Note
microphones that have been configured in Cisco Unified Communications Manager (Cisco Unified CM)
and the version of Cisco Unified CM that you are running.
The Microphone Troubleshooting screen displays the number of microphones available for testing:
•
Testing Microphones
Go to the following sections to test microphones:
•
•
•

Testing Microphones on the CTS 1300

To test microphones on the CTS 1300, follow these steps:
Place the microphones around your table. See the
Step 1
Recommendations
Field-Replaceable Unit Guide
Step 2 Log in to the Cisco TelePresence System Administration window.
Choose Troubleshooting > Hardware Setup.
Step 3
Click the Microphones radio button.
Step 4
Click Start in the Testing box to begin the test. The Microphone Calibration button is activated.
Step 5
From the microphoneCount drop-down menu, choose the 3 microphones option.
Step 6
Lightly tap each of the 3 fixed tabletop microphones and watch the audio meter on the corresponding
Step 7
display screen to see that sound registers.
Snap or clap in front of the 3 positional microphones and watch the audio meter on the corresponding
Step 8
display screen to see that sound registers.
Cisco TelePresence System Release 1.6 Administration Guide
7-94
on Cisco.com.
CTS 1300—3 "fixed" table-top microphones, 3 "positional" microphones that are mounted behind
the top front cover above the display screen: left, right, and center. These microphones establish
where the person who is speaking is seated to determine voice-activated camera switching. Each
microphone has a corresponding number of audio meters displayed on a single test screen.
Testing Microphones on the CTS 1300, page 7-94
Troubleshooting Microphones, page 7-95
Related Information, page 7-96
chapter in the
Guide.
Cisco TelePresence System Troubleshooting
Cisco TelePresence System 1300 Room
Cisco TelePresence System 1300 Assembly, First-Time Setup, and
for the correct microphone placement.
Chapter 7 Troubleshooting the CTS 1300
Cisco TelePresence System 1300
OL-13676-04