First Time Setup
Step 2
Turn on the codecs that are associated with your CTS device. The displays associated with each codec
become active. CTS displays green check marks on all displays to show bootup progress. Bootup is
complete when the system displays six check marks, as shown in
Figure 3-1
If the last check mark displayed is a red "X," there has been a compact flash error. If you receive this
Note
error, contact Cisco Technical Support.
After bootup completes, make a note of the IP address that displays on the center of the screen, as shown
Step 3
in
Figure
application. This IP address displays until you log in to Cisco TelePresence System Administration or
use Secure Shell (SSH) to log in to your
Cisco TelePresence System Release 1.6 Administration Guide
3-2
Bootup Completed
3-2. Use this information to log in to the Cisco TelePresence System Administration
Chapter 3
Figure
CTS
device.
Configuring the Cisco TelePresence System
3-1.
OL-13676-05