Table of Contents
Advertisement
Chapter 8
Troubleshooting the CTS 3000 and CTS 3200
Related Information
For more system troubleshooting information, see the
Guide
Testing the Network Connection
Use the Network Connection window to view and modify the duplex and automatic negotiation settings
for the Cisco TelePresence system Ethernet connection. Auto negotiation is set to Off by default.
You can change the following network connection settings:
•
•
To manage Auto Negotiation, follow these steps:
Choose Troubleshooting > Network Connection.
Step 1
Click the On radio button to enable auto negotiation. The Apply and Reset buttons are activated.
Step 2
When Auto Negotiation is enabled, the Duplex and Speed settings are read-only.
Note
Or
Step 3
Click the Off radio button to disable auto negotiation. The Apply and Reset buttons are activated.
Step 4
Click the Full or Half radio button to set full or half Duplex mode.
Step 5
Click Apply to save your settings or click Reset to restore the original settings.
Related Information
For more system troubleshooting information, see the
Guide
OL-13676-05
on Cisco.com.
Auto Negotiation on
Auto Negotiation off
on Cisco.com.
Cisco TelePresence System Troubleshooting
Cisco TelePresence System Troubleshooting
Cisco TelePresence System Release 1.6 Administration Guide
Testing the Network Connection
8-45
Advertisement
Table of Contents
Troubleshooting
