Table of Contents
Advertisement
Managing Configuration Issues
Step 3
Click the Off radio button to disable auto negotiation. The Apply and Reset buttons are activated.
Click the Full or Half radio button to set full or half Duplex mode.
Step 4
Click Apply to save your settings or click Reset to restore the original settings.
Step 5
Related Information
For more system troubleshooting information, see the
Guide
Managing Configuration Issues
Use the Configuration Issues window to view hardware and software versions and to reset the system to
use the factory default software image and the default configuration.
To view hardware and software versions and active images, choose Troubleshooting > Configuration
Issues. The Hardware/Software Versions page appears listing the current hardware and software
versions and active images.
Resetting the System
Caution
Once the system is reset, you will have to reconfigure the system. You will be asked twice to confirm
your choice to revert to the factory image before software will carry out this request.
Resetting the system can take over two hours to complete.
A system reset results in the following:
•
•
If you select to reset the system to use factory defaults, check the Cisco IP telephone for messages during
the reset procedure:
•
•
To reset the system image to the factory default, follow these steps:
Step 1
Choose Troubleshooting > Configuration Issues. The Hardware/Software Versions page appears
listing the current hardware and software versions and active images.
Step 2
Click the Reset to Factory Image and Factory Configuration...and Restart Cisco TelePresence
System... button. The system image location is changed and the is system restarted.
Note
If a Cisco TelePresence call is in progress, the changes will be made after the call ends.
Cisco TelePresence System Release 1.6 Administration Guide
5-34
on Cisco.com.
The CTS is reset to the software image as originally shipped.
All configuration settings are reset to the factory defaults.
Data in bold
blue
text indicates where the current system image is located for each codec in the
system.
Locations of the factory image are listed.
Chapter 5
Troubleshooting the CTS 1000
Cisco TelePresence System Troubleshooting
OL-13676-05
Advertisement
Table of Contents
Troubleshooting
