Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-60
Tighten the thumbscrews for the zoom and focus rings.
Step 8
Click Hide Camera Targets.
Step 9
Click the Setup button, then click the Auto Adjust button.
Step 10
The auto adjust procedure completes; this procedure takes several seconds.
Note
If there is insufficient light, the auto adjust procedure terminates; in this case, add more light to the room
and repeat the auto adjust procedure.
Click Done to complete the procedure.
Step 11
Focusing the Center Camera
To focus the center camera, follow these steps.
Note
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
could configure your system for the incorrect table type. To select the correct table type, complete
in the
In the Cisco TelePresence administrative GUI, click the Center radio button.
Step 1
Step 2
Click the Setup button that is located below the center screen icon.
Step 3
Click Show Focus Targets.
Red and green outline boxes display on the screen, and red and green horizontal bars display on the
bottom of the screen. The horizontal bars indicate the sharpness of focus in the boxes that use the
corresponding color. Longer bars indicate a sharper focus.
Cisco TelePresence System Release 1.6 Administration Guide
7-64
Adjusting the Camera Zoom
"Positioning the Table and Starting the Calibration Procedure" section on page
Chapter 7
Troubleshooting the CTS 1300
7-51.
OL-13676-04
Step 5
Advertisement
Table of Contents
Troubleshooting
