Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Position the table so that there is a minimum of 44 inches between the display and the front of the table,
Step 1
and make sure that the sides of the table are evenly positioned on each side of the CTS 1300.
In addition, make sure that the farthest edge of the table is no farther than 10 feet (3 meters) away from
the lower bezel of the display.
The table must be 28 to 32 inches high; 30 inches is the optimal height.
Note
Figure 7-66
Make sure that the camera assembly is level by completing the steps in the
Step 2
and Leveling the Cameras" section on page
Build the easel, and attach the large camera target to the easel, by completing the steps in the
Step 3
the Large Camera Target to the Easel" section on page
32 inches above the ground.
Step 4
Using a supported Internet browser, log in to the Cisco TelePresence System administration GUI.
Select the correct table type by completing the following steps:
Step 5
Navigate to Troubleshooting > Hardware Setup > Configuration.
a.
Click the Start button to start testing.
b.
Select the Square Table drop-down choice.
c.
Figure 7-67
OL-13676-04
Square Table Positioning
shows the table configuration menu. Be sure to choose the correct table type.
Cisco TelePresence System Release 1.6 Administration Guide
7-8.
7-11, making sure that the bottom of the target is
Managing Hardware Setup
"Removing the Camera Cover
"Attaching
7-71
Advertisement
Table of Contents
Troubleshooting
