Chapter 7
Troubleshooting the CTS 1300
Related Information
For more information about setting up and testing displays, see the
Assembly, Use & Care, and Field Replacement Unit Guide.
For more system troubleshooting information, see the
Guide
Testing Cameras
The cameras are set up successfully when images are centered and in focus on the display screens and
the white balance has been configured. The hardware setup software provides a camera Auto Adjust
feature and a way to use targets to fine-tune the camera's focus.
You must use the camera Auto Adjust feature before you can auto focus the camera. See the Calibrating
Note
the Camera section for the center, left, or right camera.
Use the information in the following sections to test and troubleshoot the camera for your system:
•
•
•
•
The camera cover comes off. It should be removed and left off until these procedures are complete.
Note
Testing the CTS 1300 Cameras
The CTS 1300 supports three cameras and various room configurations and table types. Use the
procedures in this section to troubleshoot the cameras depending on your table type.
You must first configure the table size before you can test the camera. See the
Note
"Configuring the CTS 1300 Table" section on page
types, see the
System 1300 Assembly, First-Time Setup, and Field-Replaceable Unit
The cameras are set up successfully when images are centered and in focus on the display screens, and
the white balance is configured. The hardware setup software provides a camera Auto Adjust feature and
uses targets to adjust the camera zoom and fine-tune the camera focus.
If you log out of the administration interface, you must re-select the correct table type when you log back
Note
in; otherwise, you could configure your system for the incorrect table type. To select the correct table
type, complete
page
Use the information in the following sections to set up the CTS 1300 camera for testing:
OL-13676-04
on Cisco.com.
Testing the CTS 1300 Cameras, page 7-7
Understanding Camera Setup Choices for Room Lighting, page 7-91
Troubleshooting Cameras, page 7-91
Related Information, page 7-92
Supported Table Types and Minimum Room Dimensions
Step 5
in the
"Positioning the Table and Starting the Calibration Procedure" section on
7-51.
Cisco TelePresence System 1300
Cisco TelePresence System Troubleshooting
7-3. For more information about the supported table
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
section of the
Cisco TelePresence
Guide.
7-7