Configuring The Cisco Telepresence System; Contents; First Time Setup; Loading Cts Administration Software - Cisco CTS-3010 Administration Manual

Administration guide
Hide thumbs Also See for CTS-3010:
Table of Contents

Advertisement

Configuring the Cisco TelePresence System

Revised: June, 2010, OL-13676-05

Contents

This chapter contains the following sections:

First Time Setup

To set up your Cisco TelePresence System (CTS) for the first time, you must first load the CTS
Administration software and bootup the system. Proceed to

Loading CTS Administration Software

CTS Administration Software is factory-installed on each codec and loads during initial bootup. To boot
up CTS Administration Software, follow these steps:
Step 1
Power on the PDU that is on the bottom of the CTS cabinet by turning the switch to the On position.
OL-13676-05
First Time Setup, page 3-1
IP Settings, page 3-5
Network Settings, page 3-9
Cisco Unified Communications Manager Settings, page 3-10
Address Book, page 3-11
Telephony Settings, page 3-11
SNMP Settings, page 3-13
System Settings, page 3-14
Troubleshooting Your Configuration, page 3-17
Upgrading CTS Codec Firmware, page 3-19
Managing Passwords, page 3-20
Where to Go Next, page 3-21
C H A P T E R
Loading CTS Administration
Cisco TelePresence System Release 1.6 Administration Guide
3
Software.
3-1

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Telepresence system

Table of Contents