Troubleshooting Presentation Devices - Cisco CTS-3010 Administration Manual

Managing Hardware Setup

Troubleshooting Presentation Devices

Use the information in the following sections to troubleshoot presentation devices:
•
•
Multiple Input Devices
The Cisco TelePresence System can display information from multiple input devices during a meeting.
If multiple input devices are sending information, the projector displays the input from the last
presentation device sending information. If an input device image is not being seen on the projector
screen, try the following:
•
•
Presentation Devices
Use the information in
Cisco TelePresence System Release 1.6 Administration Guide
9-28
Multiple Input Devices, page 9-28
Presentation Devices, page 9-28
VGA devices—Unplug the device from the VGA cable, wait 5 seconds, and then plug the device
back in.
Document cameras—Turn the camera off, wait 5 seconds, and restart the device.
Table 9-7
Chapter 9
to troubleshoot presentation devices.
Troubleshooting the CTS 3010 and CTS 3210
OL-13676-05