Cisco CTS-3010 Administration Manual page 266

Managing Hardware Setup
Step 9 Replace the camera cover onto the camera cluster, then tighten the cover release screws to secure the
cover to the camera.
Figure 7-65 Replacing the Camera Cover
Configuring the CTS 1300 for Use With a Square Table
This section includes the procedures you perform to configure the CTS 1300 software and cameras for
use with a room that has a square table and includes the following topics:
•
•
•
•
•
•
•
Positioning the Table and Starting the Calibration Procedure
To correctly position the table and configure the Cisco TelePresence software for use with the CTS 1300
cameras, follow these steps.
Cisco TelePresence System Release 1.6 Administration Guide
7-70
Positioning the Table and Starting the Calibration Procedure, page 7-70
Calibrating the Center Camera, page 7-73
Calibrating the Right Camera, page 7-76
Calibrating the Left Camera, page 7-79
Focusing the Center Camera, page 7-82
Focusing the Right Camera, page 7-84
Focusing the Left Camera, page 7-85
Cover
release
screws
Cover
release
screws
Chapter 7 Troubleshooting the CTS 1300
Cover
release
screws
OL-13676-04