Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-19
Tighten the thumbscrews for the zoom and focus rings.
Step 7
Click Hide Camera Targets to remove the alignment images.
Step 8
Click the Setup button, then click the Auto Adjust button. The auto adjust procedure completes. This
Step 9
procedure takes several seconds.
If there is insufficient light, the auto adjust procedure terminates. In this case, add more light to the room
Note
and repeat the auto adjust procedure.
Click Done to complete the procedure.
Step 10
Calibrating the Left Camera
To adjust the zoom and focus the left camera, follow these steps.
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
The directions left and right refer to the assembly as you face the display.
Note
Slide the large camera target to the left 10 feet so that the right edge of the target is lined up with the
Step 1
tape marker that you placed on the table in the
Figure 7-20
Cisco TelePresence System Release 1.6 Administration Guide
7-24
Adjusting the Camera Zoom
"Positioning the Table and Starting the Calibration Procedure" section on page
shows placement of the left camera target.
Chapter 7
"Calibrating the Center Camera" section on page
Troubleshooting the CTS 1300
Step 5
7-51.
7-18.
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
