Digital Media Player - Cisco CTS-3010 Administration Manual

Administration guide
Hide thumbs Also See for CTS-3010:
Table of Contents

Advertisement

Managing Hardware Setup
Click the Light State On or Light State Off button to change the current state of the shroud light.
Step 6
Click Stop to end the test. The state of the light reverts to its default setting as it was configured in the
Step 7
Cisco Unified CM.

Digital Media Player

The Digital Media Player (DMP) feature lets you select a secondary audio input source when you are
not in a TelePresence call.
To test the DMP, follow these steps:
Step 1
Log in to the Cisco TelePresence System Administration window.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3
Click the DMP tab.
Step 4
Click Start in the Testing box to begin testing the secondary audio input.
The DMP settings should match how the secondary auxiliary audio input is physically connected to the
Note
codec.
Click Stop to end the test.
Step 5
Cisco TelePresence System Release 1.6 Administration Guide
4-30
If the shroud light feature is enabled, the Light State On button will be highlighted.
If the shroud light feature is disabled, the Light State Off button will be highlighted.
If you have a PC attached, the Secondary Audio Input Source PC button is highlighted. When
Secondary Audio Input Source is set to PC, the audio input is active while the presentation source
is active, both in and out of a call.
If you have a DMP attached, the Secondary Audio Input Source DMP button is highlighted. When
set to DMP, audio input is only active outside of a call if DMP is active (during business hours
defined by Cisco Unified CM).
Chapter 4
Troubleshooting the CTS 500
OL-13676-05

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Telepresence system

Table of Contents