Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Resetting the Projector
To reset the projector, follow these steps:
Log in to the Cisco TelePresence System Administration window.
Step 1
Choose Troubleshooting > Hardware Setup.
Step 2
Click the Presentation Devices radio button.
Step 3
Click Start in the Testing box. The Presentation Source buttons are activated.
Step 4
Click Set Projector Defaults to reset the projector to the default settings.
Step 5
Click Stop in the Testing box to complete the task.
Step 6
Troubleshooting Presentation Devices
Use the information in the following sections to troubleshoot presentation devices:
•
•
Multiple Input Devices
The Cisco TelePresence System can display information from multiple input devices during a meeting.
If multiple input devices are sending information, the projector displays the input from the last
presentation device sending information. If an input device image is not being seen on the projector
screen, try the following:
•
Presentation Devices
Use the information in
OL-13676-04
Multiple Input Devices, page 7-99
Presentation Devices, page 7-99
VGA devices—Unplug the device from the VGA cable, wait 5 seconds, and then plug the device
back in
Table 7-7
to troubleshoot presentation devices.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
7-99
Advertisement
Table of Contents
Troubleshooting
