Managing Hardware Setup
See
Figure 7-54
positioning for a round table.
Position the target to that it is parallel with the wall.
In the Cisco TelePresence administrative GUI, click the Left radio button.
Step 2
Step 3
Click Show Camera Target.
Focus the left camera by completing the following steps:
Step 4
Loosen the focus ring thumbscrew on lens of the center camera.
a.
Rotate the focus ring until the black plus sign on the target is clearly in focus.
b.
Note
Figure 7-74
Zoom ring
Cisco TelePresence System Release 1.6 Administration Guide
7-80
for the location of the left target. The positioning for a square table is the same as the
The camera lens has two adjustment rings, one for focus and one for zoom. The focus ring is on
the inside.
Location of Focus and Zoom Ring
Chapter 7
Troubleshooting the CTS 1300
Focus ring
OL-13676-04