Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-56
Side to side
adjust screw
Adjust the camera zoom by completing the following steps:
Step 6
Loosen the thumbscrew for the zoom ring on the camera lens.
a.
Note
Align and center the camera by competing the following steps:
b.
•
•
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
c.
Note
Cisco TelePresence System Release 1.6 Administration Guide
7-60
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T".
Align the black curved line on the left of the target until it touches the left side of the display
screen.
Center the black cross on the target with the red cross on the display screen.
Because of the position of the target, the target appears smaller and not parallel to the camera.
This view is normal. Participants will appear lifelike after you complete the first-time setup
procedure.
Chapter 7
Right
adjust
screw
Side to side
adjust screw
Up/down
adjust
screw
Troubleshooting the CTS 1300
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
