Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-39
Left participant
sitting position
camera target
In the Cisco TelePresence Administration window, click the Left radio button.
Step 2
Step 3
Click Show Camera Target.
Step 4
Focus the left camera by completing the following steps:
a.
Loosen the focus ring thumbscrew on the lens of the center camera.
b.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
Note
Figure 7-40
Zoom ring
Adjust the camera mounting plate to center the red plus sign (+) on the display inside the black plus sign
Step 5
(+) on the target.
The screws that you use to adjust the camera are shown in
OL-13676-04
Positioning Easel and Target for Small Racetrack Table
Display
Alignment
marker
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure
7-40. The focus ring is the one that is nearest to the wall.
Location of Focus and Zoom Ring
Focus ring
Figure
7-41. Use a 2.5 mm Allen wrench.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
7-43
Advertisement
Table of Contents
Troubleshooting
