Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-47
Configuring the CTS 1300 for Use With a Round Table
This section includes the procedures you perform to configure the CTS 1300 software and cameras for
use with a room that has a round table and includes the following topics:
•
•
•
•
•
•
•
Positioning the Table and Starting the Calibration Procedure
To correctly position the table and configure the Cisco TelePresence software for use with the CTS 1300
cameras, follow these steps.
OL-13676-04
Replacing the Camera Cover
Positioning the Table and Starting the Calibration Procedure, page 7-34
Calibrating the Center Camera, page 7-54
Calibrating the Right Camera, page 7-57
Calibrating the Left Camera, page 7-61
Focusing the Center Camera, page 7-64
Focusing the Right Camera, page 7-66
Focusing the Left Camera, page 7-67
Cover
release
screws
Cover
release
screws
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Cover
release
screws
7-51
Advertisement
Table of Contents
Troubleshooting
