Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-16
Step 2
Click the Right radio button in the Cisco TelePresence Administration window.
Step 3
Click Show Camera Target.
Step 4
Focus the right camera by completing the following steps:
a.
Loosen the focus ring thumbscrew on the lens of the center camera.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
b.
Note
Figure 7-17
Zoom ring
Cisco TelePresence System Release 1.6 Administration Guide
7-22
Positioning the Right Target
Alignment
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure
7-17. The focus ring is the one that is nearest to the wall.
Location of Focus and Zoom Ring
Display
Right participant
sitting position
marker
camera target
Focus ring
Chapter 7
Troubleshooting the CTS 1300
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
