Table of Contents
Advertisement
Managing Hardware Setup
Figure 7-14
Side to side
adjust screw
Adjust the camera zoom by completing the following steps:
Step 9
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
b.
Adjust the camera zoom so that the black curved lines on each side of the target touch the edge of
the display screen, as shown in
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Cisco TelePresence System Release 1.6 Administration Guide
7-20
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T."
Up/down
adjust
screw
Figure
7-15.
Chapter 7
Troubleshooting the CTS 1300
Right
adjust
screw
Side to side
adjust screw
OL-13676-04
Advertisement
Table of Contents
Troubleshooting
