Managing Hardware Setup
The red and green bars do not have to be exactly the same length, but get them as close as you can.
Note
Without moving the focus ring, tighten its thumbscrew.
e.
Click Done to complete the right camera focusing procedure.
Step 7
Replacing the Camera Cover
To replace the camera cover, follow these steps:
Place the foam lens covers onto the camera lenses, as shown in
Step 1
Figure 7-27
Replace the camera cover onto the camera cluster, then tighten the cover release screws to secure the
Step 2
cover to the camera, as shown in
Cisco TelePresence System Release 1.6 Administration Guide
7-32
Attaching the Foam Lens Covers to the Camera Lenses
7
Figure
Figure
7-28.
Chapter 7
Troubleshooting the CTS 1300
7-27.
OL-13676-04