Cisco CTS-3010 Administration Manual page 86

Managing Hardware Setup
Step 3 Click Show Focus Targets.
Reposition the targets by completing the following steps:
Step 4
Lean the large target against a chair or other surface so that it is taller than it is wide.
a.
Move the large target 6 to 8 feet (1.8288 to 2.4384 meters) from the camera so that the red box
b.
encloses some of the patterns on the large target when you view the display, as shown in
Use the easel to support the small target, as shown in
c.
Place the small target approximately 0.9 meters (3 feet) in front of the camera so that the green box
d.
encloses some of the patterns on the small target when you view the display, as shown in
Make that there are no objects between the targets and the camera.
Note
Figure 4-7
Large
target
Small
target
Cisco TelePresence System Release 1.6 Administration Guide
4-14
Setting Up Focus Targets
Easel
Chapter 4
Figure 4-7.
5 ft
(1.5 m)
3 ft
(0.9 m)
Troubleshooting the CTS 500
Figure 4-7.
Figure 4-8.
OL-13676-05