Chapter 15 First-Time Setup; Configuring Cisco Unified Communications Manager For Your Cisco Telepresence System - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

First-Time Setup
Revised: May 20, 2015, OL-27038-01
This chapter describes the tasks you perform to set up your system for the first time and includes the
following sections:
•
•
•
•
•
•
Configuring Cisco Unified Communications Manager for Your
Cisco TelePresence System
Before you can use your system, you need to configure your system in Cisco Unified Communications
Manager (Unified CM).
You can configure your system and complete all steps in this chapter prior to configuring your device in
Unified CM, but you will not be able to complete any of the following actions until you register your
device:
•
•
•
To configure your device in Unified CM, complete the following steps:
OL-27038-01

Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System,

page 15-1
Powering on the System and Enabling the Cisco TelePresence Administration Software GUI,
page 15-2
Powering on the System and Enabling the Cisco TelePresence Administration Software GUI,
page 15-2
Configuring an Alternate TFTP Server (Optional), page 15-5
Setting Up a TX9000 or TX9200 System That Uses a Static Network Address, page 15-5
Setting Up CTS Components, page 15-7
The Touch device cannot download its software from Unified CM and you receive an error in the
logs.
The Cisco TelePresence device cannot place or receive calls.
The device appears as either a Cisco TelePresence System 500-32 or a Cisco TelePresence
System 1000 in the Cisco TelePresence Administration GUI.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
15
C H A P T E R
15-1