Installing The Power Supply Bay - Intel SR870BN4 - Server Platform - 0 MB RAM Product Manual

Installing the Power Supply Bay

1. Verify that the hot-swap power supplies have been removed from the power supply bay.
2. Place the front of the power supply bay in the chassis as shown in Figure 120, and verify that
the locating pins on the side of the power supply bay (A in Figure 120) engage the slots in the
bottom of the chassis.
3. Grasp the captured retaining screw (B in Figure 120) and lift up the retaining bracket.
4. While holding the retaining bracket up, push the power supply bay forward until the locating
pins reach the end of their travel in the slots (B in Figure 120).
5. Release the captured retaining screw and allow the retaining bracket to drop into place (C in
Figure 120.
6. Tighten the retaining screw (D in Figure 120) securing the retaining bracket to securely dock
the power supply bay.
7. Tighten the two retaining screws on the side of the chassis (E in Figure 120).
8. Replace the hot-swap power supplies.
9. Replace the top back cover.
10. Replace the I/O bay.
Intel® SR870BN4 Server System Product Guide
E
B
A
Figure 120. Installing the Power Supply Bay
D
C
OM12963
245