Intel SR870BN4 - Server Platform - 0 MB RAM Product Manual page 153

Table 29. Terminal Mode Text Commands
Command Switches
SYS PWD -U USERNAME
<password>
-N <password>
-X
SYS
TMODE
SYS SET
BOOT XX
YY ZZ AA
BB
Intel® SR870BN4 Server System Product Guide
Description
Used to activate a terminal mode session. USERNAME corresponds to
the ASCII text for the username. <password> represents a printable
password (up to 16 characters). If <password> is not provided, then a
Null password (all binary 0's) is submitted. Passwords are case
sensitive.
Either the SYS PWD command (or Activate Session IPMI message)
must be successfully executed before any command or IPMI messages
are accepted. Note that a modem connection may be automatically
dropped if multiple bad passwords are entered.
-N represents a Null username. <password> represents a printable
password (up to 16 characters). If <password> is not provided, then a
Null password (all binary 0's) is submitted. Passwords are case
sensitive.
Either the SYS PWD command (or Activate Session IPMI message)
must be successfully executed before any command or IPMI messages
are accepted. Note that a modem connection may be automatically
dropped if multiple bad passwords are entered.
-X immediately 'logs out' any presently active session. Entering an
invalid password with -U or -N also has the same effect.
Used as a 'no-op' confirm that Terminal Mode is active. BMC returns an
OK response followed by "TMODE".
Sets the boot flags to direct a boot to the specified device following the
next IPMI command or action initiated reset or power-on. XX...BB
represent five hex-ASCII encoded bytes, which are the boot flags
parameter in the Boot Option Parameters. See the Boot Option
Parameters Table below for more information.
Upon receiving this command, the BMC automatically sets the 'valid bit'
in the boot options and sets all the Boot Initiator Acknowledge data bits
to 1b.
continued
153