Cisco MCS-7825-H3-IPC1 Service Manual page 780

CISCO-CDP-MIB
remote device is not currently manageable via any network protocol, this object has the special value
of the IPv4 address 0.0.0.0. If the most recently received CDP message did not contain any primary
address at which the device prefers to receive SNMP messages, then this object is not instanstiated.
::= { cdpCacheEntry 20 }
cdpCacheSecondaryMgmtAddrType OBJECT-TYPE
SYNTAX CiscoNetworkProtocol
MAX-ACCESS read-only
STATUS current
DESCRIPTION
An indication of the type of address contained in the corresponding instance of
cdpCacheSecondaryMgmtAddress.
::= { cdpCacheEntry 21 }
cdpCacheSecondaryMgmtAddr OBJECT-TYPE
SYNTAX CiscoNetworkAddress
MAX-ACCESS read-only
STATUS current
DESCRIPTION
This object indicates the alternate network layer address (other than the one indicated by
cdpCachePrimaryMgmtAddr) at which the device will accept SNMP messages as reported in the
most recently received CDP message. If the corresponding instance of
cdpCacheSecondaryMgmtAddrType has the value ip(1), then this object would be an IP-address. If
the most recently received CDP message did not contain such an alternate network layer address,
then this object is not instanstiated.
::= { cdpCacheEntry 22 }
cdpCachePhysLocation OBJECT-TYPE
SYNTAX DisplayString
MAX-ACCESS read-only
STATUS current
DESCRIPTION
Indicates the physical location, as reported by the most recent CDP message, of a connector which
is on, or physically connected to, the remote device's interface over which the CDP packet is sent.
This object is not instantiated if no Physical Location field (TLV) was reported by the most recently
received CDP message.
::= { cdpCacheEntry 23 }
cdpCacheLastChange OBJECT-TYPE
SYNTAX TimeStamp
MAX-ACCESS read-only
STATUS current
DESCRIPTION
Cisco Unified Communications Manager Managed Services Guide
7-138
Chapter 7 Cisco Management Information Base
OL-22523-01