Cisco-Syslog-Mib - Cisco MCS-7825-H3-IPC1 Service Manual

CISCO-SYSLOG-MIB

CISCO-SYSLOG-MIB
This is a reformatted version of CISCO-SYSLOG-MIB. Download and compile all of the MIBs in this
Note
section from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
This MIB provides a means to gather syslog messages generated by the Cisco IOS. Various textual
messages are generated by the Cisco IOS. Cisco IOS can be configured such that these messages are sent
to a syslog server. With this MIB these same messages can also be received via the SNMP. These
messages are hereupon referred to as syslog messages in this document.
Messages generated as a result of entering CLI debug commands are not made available via the SNMP
Note
at this time.
All Cisco IOS syslog messages have timestamps (optional), facility names (where the message came
from), severity, message name, and message text. The following example is often seen:
%SYS-5-CONFIG_I: configured from console where facility=SYS, severity=5, message
name=CONFIG_I.
Before you can compile CISCO-SYSLOG-MIB, you need to compile the MIBs listed below in the order
listed.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Additional downloads are:
•
•
The following are contained in this section:
•
•
•
•
Cisco Unified Communications Manager Managed Services Guide
7-144
SNMPv2-SMI
SNMPv2-TC
SNMPv2-CONF
CISCO-SMI
INET-ADDRESS-MIB
SNMP-FRAMEWORK-MIB
RFC1155-SMI
RFC-1212
RFC-1215
SNMPv2-TC-v1
CISCO-SYSLOG-MIB
OID File: CISCO-SYSLOG-MIB.oid
Capability File: CISCO-SYSLOG-CAPABILITY
Revisions, page 7-145
Definitions, page 7-145
Object Identifiers, page 7-145
Textual Conventions, page 7-145
Chapter 7 Cisco Management Information Base
OL-22523-01