Cisco MCS-7825-H3-IPC1 Service Manual page 47

Chapter 2 New and Changed Information
Reason Code
AutoRegisterDBConfigTimeout
DeviceTypeMismatch
AddressingModeMismatch
The following provides the reason codes that are added for EndPointUnregistered alarm:
Reason Code
NoEntryInDatabase
DatabaseConfigurationError
DeviceNameUnresolveable
MaxDevRegExceeded
InitializationError
PowerSavePlus
CallManagerForcedRestart
SourceIPAddrChanged
SourcePortChanged
RegistrationSequenceError
InvalidCapabilities
OL-22523-01
Description
(SCCP only) Unified CM timed out during auto-registration of a device. The
registration profile of the device did not get inserted into the database in time. The
device will automatically attempt to register again.
The device type reported by the device does not match the device type configured
on the Unified CM.
(SCCP only) Cisco Unified CM detected an error related to the addressing mode
configured for the device. One of the following errors was detected:
The device is configured to use only IPv4 addressing, but did not specify an
•
IPv4 address.
The device is configured to use only IPv6 addressing, but did not specify an
•
IPv6 address.
Description
Device not configured properly in the Cisco Unified CM database.
Device configuration error in the Cisco Unified CM database.
The Cisco Unified CM is unable to resolve the device name to an IP Address
internally.
Maximum number of device registrations have been reached.
Indicates that an error occurred when the Cisco Unified CM tries to initialize the
device.
The device powered off as a result of the Power Save Plus feature that is enabled for
this device. When the device powers off, it remains unregistered from Cisco Unified
CM until the Phone On Time is defined in the Product Specific Configuration for
this device.
(SIP Only) The device did not respond to an Apply Config request and as a result,
Unified CM sent a restart request to the device. The device may be offline due to a
power outage or network problem. Confirm that the device is powered-up and that
network connectivity exists between the device and Cisco Unified CM.
(SIP Only) The device has been unregistered because the IP address in the Contact
header of the REGISTER message has changed. The device will be automatically
reregistered. No action is necessary.
(SIP Only) The device has been unregistered because the port number in the Contact
header of the REGISTER message has changed. The device will be automatically
re-registered. No action is necessary.
A device requested configuration information from the Unified CM at an
unexpected time. The Unified CM no longer had the requested information in
memory.
(SCCP only) Cisco Unified CM detected an error in the updated media capabilities
reported by the device. The device reported the capabilities in one of the
StationUpdateCapabilities message variants.
Cisco Unified Communications Manager Managed Services Guide
Cisco Unified Communications Manager, Release 8.5(1)
2-5